N1mm logger cw memories how to#
N1mm logger cw memories serial#
N1mm logger cw memories code#

The resulting performance is solid at least through 30wpm.

Leave all other tasks at a Base Priority of Normal.

In the drop down window select AboveNormal.

Right click on the N1MM Logger process and select Set Priority from the pop-up box.

The processes PowerSDR and taskmgr.exe should have a Base Priority of High.

Press + + simultaneously and select Windows Task Manager's Processes Tab.

In the PowerSDR menu bar, navigate to Setup -> General -> Options and select a Process Priority of High.

That is insuring smooth CW transmission.Īssuming on contest day there will be several programs running on your machine, application priorities must be set appropriately.

Terminate N1MM Logger and activate your normal CAT program.

Select ' None' in the Keyer Secondary Port box.

In the PowerSDR menu bar, navigate to PowerSDR S etup -> DSP -> Keyer To restore control to your normal CAT program for PowerSDR:

N1mm logger cw memories code#

With MON activated listen to the code quality.Īssuming you can hear the code and appropriate power is being generated you are done.

Check the TX Meter to make sure signal is being sent.

Click F2 and observe the CW being sent by your SDR.

Enter a test string behind one of the Logger function keys say F2.

(remember to use a dummy load to minimize QRM or very low power) Select an unused portion of a CW band and tune your SDR. You should now be ready to send CW strings from N1MM. PTT Line and Key Line controls will appear.

In the Connections Panel perform the following changes.

On this tab make the following changes to your basic setup:.

In the PowerSDR menu bar, navigate to PowerSDR Setup -> DSP -> Keyer.

Assuming basic CAT communications has been established enable PowerSDR to process 'paddle closures' from N1MM Logger.

Verify communications by selecting various frequencies in PowerSDR's VFO A window and verifying the same change in Logger's blue Title bar.

If still open, click Apply and OK as appropriate to close N1MM Configurer and PowerSDR Setup windows.

Now verify communication between Logger and PowerSDR by performing the following test:

After clicking the Set button and configure the following com port parameters:Ĭlick on OK when complete.

Setup the com port settings for the Kenwood radio

In the Logger menu bar navigate to Config -> Configure Ports, Telnet Address, Other and perform the following:.

Setup N1MM Logger's end of the CAT channel

In the ID as: control, select PowerSDR.

In the CAT Control panel, check the Enable CAT box.

In the PTT Control Panel, select Port COM6 and l eave the RTS and DTR check boxes blank.

In the PowerSDR menu bar, navigate to PowerSDR Setup -> CAT Control and perform the following:.

N1mm logger cw memories serial#

Setup PowerSDR's end of the PTT Serial port connection. Any other valid vCom pair may be substituted. For this example PowerSDR uses COM6 and N1MM uses COM7 for the virtual port pair.

Using the vCom Configurator, establish a virtual com port pair to serve as the PTT and CAT virtual serial port between N1MM and PowerSDR It works on a Pentium 3D PC with 1Gbyte of RAM and Windows XP Professional box. This procedure has only been tested with N1MM Logger v7.0.0, PowerSDR v1.10.1 and N8VB vCom v1.0.0.4.

N1mm logger cw memories how to#

How to Setup the N1MM Logger v7.0.0 with PowerSDR 1.x